- AUTOMOWER 220 AC SOFTWARE UPDATE HOW TO
- AUTOMOWER 220 AC SOFTWARE UPDATE SERIAL NUMBER
- AUTOMOWER 220 AC SOFTWARE UPDATE INSTALL
Choose Programming -> Program in the top menu.ħ.
AUTOMOWER 220 AC SOFTWARE UPDATE SERIAL NUMBER
At the bottom of theĪutocheck EXP window the model name (305) and serial number should be visible.Ħ. Confirm that Autocheck EXP establish connection with the mower. Switch on the Automower® 305 and connect it to Autocheck EXP via a USB cable (partĥ. Check that channel G3 is selected at the bottom left corner of the Autocheck EXP window.Ĥ.
AUTOMOWER 220 AC SOFTWARE UPDATE INSTALL
If there is any update available, install it before continue to step 3.ģ. Check that there are no uninstalled updates of Autocheck EXP.
AUTOMOWER 220 AC SOFTWARE UPDATE HOW TO
Please follow below guide for how to make an automatic programming in Autocheck EXP.Ģ. Former Autocheck 9.X can not be used with Automower® 305. Use Autocheck EXP (part number 577 85 81-01) to make an automatic programming of the new Problem between MMI circuit board and Main circuitĬheck that wire between MMI circuit board andĬheck that wire between keyboard and MMI circuit The message code is not stored in the message history list nor in Autocheck logfile. The message code appears within parenthesis after the message in mowerĭisplay. The mower is constantly under observation.įor improved diagnostic some extra message-codes have been added to the message Demonstration of Automower® without using demo mode may only be done if Always remove the blades from the blade disc whenever Automower® isĭemonstrated in public areas for increased safety. Switched off in demo mode for increased safety. In public demo areas, for example inside a dealer’s shop. It is strongly recommended to use demo mode whenever running Automower® The mower varies running with charging at In demo modeĪutomower® 305 works without starting the blade disc. This should not be considered as a valid test.ĭemo mode is available in menu Tools -> Special Settings -> Demo Mode. If Test In is done before Test Out the mower will run on top of wire to the charging station,.The Sub system software is updated together with the Main and MMI softwares when Automatic programming is done in Autocheck EXP.Īs a result of improved Calibration of Guide some changes have been done in the Test Out and That software controls the cutting motor. In mower menu Tools -> Info -> General, the line “Sub-ver” has been added. That the guide width setting should have the same width (50 cm and 100 cm), irrespective ofĬalibration of guide is done automatically first time the mower leaves the charging station in theĪfter changing guide width to Medium or Wide
Improvements have been done in the calibration of guide. Several minor SW improvements (not described in detail in this SB) Test Out and Test In procedure has been improved The new softwares includes the following changes: It is recommended to update all Automower® 305 before delivery to New Main software, MMI (Man Machine Interface) software and Sub System software have been
0 kommentar(er)
